Fully automatic soldering machine is used for welding various electronic components, such as capacitor LED, array, wire, switch, charger, electroacoustic products, transformer, PCB and other components. It is often used in consumer electronics, automotive electronics, medical electronics, LED lighting and other fields. So what is the characteristic of the automatic tin soldering machine compared with the ordinary solder machine?

1. The TM soldering head with fast temperature recovery can be installed in the whole series of machines designed for the future trend of lead-free soldering. The high-precision thermoelectric coupler is located in the front of the soldering iron. Therefore, it is possible to sense the subtle changes in the temperature of the front end of the soldering head.

You can reach 300 degrees C in six seconds.

The cartridge head designed by cassette can be replaced quickly and conveniently and easily.

Various forms of soldering iron can quickly solve the difficult solder technology.

2, tin tin blasting tin feeder ZSB can be installed in a full range of aircraft.

At the same time of precise tin feeding, the knife gear protrudes on the side of the tin wire to prevent flux leakage, so that the flux boiling will not cause "tin explosion" in the soldering process to ensure the cleanliness of the welding parts, and there will be no flux or tin balls produced by tin explosion affecting other sensitive parts on the PCB board.

3. RSP/RSL soldering iron set RSP and RSL with auxiliary tin feeding function are specially designed for automatic solder.

The feeding position of the two feeding tin on the top of the iron can be adjusted by adjusting the upper and lower positions of the positioning parts. The first section of tin feeding can make the soldering head or welding parts pre-adhere tin, which can make the welding results faster and more perfect.

4, can directly blow nitrogen gas cartridge iron group

The nitrogen and iron head nozzle together, the nitrogen gas can be preheated after the soldering iron tip to blow out, with a small amount of nitrogen can meet the process requirements.